Connection details:
| Brown |
(pin 1) |
GND (ground) |
| Blue |
(pin 2) |
Input signal “engine running” |
| Orange |
(pin 3) |
Relay 3 no “engine running”
signal 24Vdc/1A output (2 sec. delayed) |
| White |
(pin 4) |
Relay 1 no “engine start” |
| White |
(pin 5) |
Relay 1 c “engine start” |
| Red |
(pin 6) |
+ 24Vdc power supply |
| Yellow |
(pin 7) |
Input signal “vehicle running” |
| Black |
(pin 8) |
Relay 2 nc “engine stop” |
| Green |
(pin 9) |
Relay 2 c “engine stop” |
| Green |
(pin 10) |
Relay 2 no “engine stop” |
Installation: Rx1 R
General description
After switching on the power supply, the internal buzzer sounds (0.1 second).
After pressing a transmitter button, the buzzer sounds (0.1 second) and an output is switched on for a maximum of 5 seconds:
- when blue (“engine running”) > 20 Volt, relay 2 is switched on (engine stop).
- when blue (“engine running”) < 18 Volt, relay 1 is switched on (engine start).
If the signal “engine running” responds to starting/stopping within 5 seconds, the corresponding relay is switched off immediately. If the signal “engine running” doesn’t respond within 5 seconds, the relay will be switched off also.
If during the 5 seconds time that a relay is active, (engine start or stop) a transmitter button is pressed, the relay is switched off immediately and the buzzer sounds twice.
When the signal “vehicle running” > 2 V, the engine cannot be started/stopped. The buzzer sounds 1 second.
Transmitter programming
The remote control comes with a preprogrammed transmitter code.
If a new or different transmitter is to be used with the receiver, this new transmitter code must be programmed into the receiver.
Procedure:
- Press the small button briefly (next to the antenna) until the buzzer sounds;
- Press the (new) transmitter button within 8 seconds (every second the buzzer sounds);
- When the new code is received, the buzzer sounds 3 times (the new code is now programmed). If the programming has not succeeded (in time), the buzzer sounds for 1 second. Repeat the procedure;
- Programming is ready.
Specifications
Power supply (red and brown)
Voltage nom: + 24 Vdc (red +, brown -)
Voltage min: + 10.4 Vdc
Voltage max: + 30.0 Vdc
Current consum: 6 mA@24Vdc
Input (blue “engine running”)
Signal detection: + 5.6...30 Vdc
Input (yellow “vehicle running”)
Signal detection: + 2...30 Vdc
Output
Type: Relay
Protection: none
Current cap: 1A
Installing Rx1
Order of connections
- Connect the colored wires to the vehicle system according to the circuit drawing;
- Connect the 10-ways connector to the Rx1 module;
- Connect the aerial (BNC) to the Rx1 module;
- Test the installation (handbrake on, ignition on, press a transmitter button).
Safety
Follow the instructions below:
- To prevent the engine from stopping during driving, the Rx1 power supply must be drawn from the handbrake circuit. When the handbrake is pulled on, the Rx1 will power up.
- The yellow wire must be connected to a “vehicle running” signal. When the vehicle is running, the Rx1 is prevented to switch on its relay no. 1 and 2.
- Position the Rx1 module in the vehicle’s cabin under the dashboard, in a dry place.
|
